Dynon Avionics Accessories
Dynon Avionics accessories for all their units.
Mounting trays, sensor modules, cables, engine sensors, servos, servo mountings kits and backup batteries.
A new network connection device, the SV-NET-HUB, is now available to make it easier to install the SkyView system. With five ne...more >>
Dynon's new SkyView system ADAHRS module (Air Data Attitude Heading Reference System). Includes OAT probemore >>
Dynon's new SkyView system backup ADAHRS module (Air Data Attitude Heading Reference System). Includes ...more >>
Dynon's new SkyView system Engine Management (EMS) module. Connects to SkyView network and interfaces to engine and fuel sensors.more >>
Dynon's new SkyView system Engine Management (EMS) module for the Rotax 912iS engine with integrated data bus. Connects to SkyV...more >>
SkyView GPS Receiver: The SV-GPS-250 is a sensitive, WAAS enabled GPS receiver and antenna. The advantage of having the receive...more >>
Full 2020 ADS-B Out compliance for your SkyView and AF-5000 Series EFIS with SV-XPNDR-261 Transponder.
The new SV-GPS-2020 G...more >>
The EFIS-D10A/EFIS-D100's attitude algorithm is normally aided by pitot-based airspeed information. If the EFIS’s airspeed sour...more >>
Dynon's new SkyView system Lithium-Ion remote battery unit. One required for each SkyView display. In event of power failure, ...more >>
Dynon Network cable with both connectors fitted. Available in 3 and 6 foot versions for connecting displays and modules.more >>
Please select an option...
Dynon's Combined Angle Of Attack and Pitot probe, unheated.more >>
Dynon Network cable with one connector fitted and one loose. Available in 10, 15, 20, 25 and 30 foot lengths.more >>
Please select an option...
The Dynon SV-NET-SERVO Cable Kit helps wire the autopilot servos. It includes 20 feet of Tefzel wires: two pairs of twisted 22 ...more >>
The SV-HARNESS-INT Intercom harness includes wiring for the following:
25 pin female D-Sub connector with the following conn...more >>
Network cable splitter. 1' (300mm) long, includes gender changer.more >>
SkyView ethernet cable for sharing database information between the displays in a system.more >>
Internally illuminated (backlit) dedicated button for activating the "LEVEL" mode in SkyView's integrated Autopilot.
Dynon's Combined Angle Of Attack and Pitot probe, heated (14v). Supplied with controller.more >>
SV-HARNESS-XPNDR for use with either Class I or Class II Mode-S transponder. more >>
SV-HARNESS-ADSB for use with the SkyView system ADS-B traffic receiver. 15ft long.
Suitable for use with:
The SV-KNOB-DIMMER allows the brightness level of SkyView / SkyView SE displays, and Dynon Avionics panel units, to be adjusted...more >>
The new Dynon SV-ARINC-429 module makes SkyView compatible with certified GPS receivers, integrating with radios such as the Ga...more >>
Dynon’s New Dual Band ADS-B Traffic and Weather Receiver
The dual band SV-ADSB-472 receives ADS-B traffic via 978 MHz (UAT) an...more >>
Dynon's Combined Angle Of Attack and Pitot boom probe, straight, unheated.more >>
Dynon SV-HARNESS-D37 Display Harness
Display wiring harness for D700/1000. Aircraft grade Tefzel wiring. Connections for po...more >>
Dynon DB9 Male/Male Adapter (Network Bypass Adapter)
Used to connect two female SkyView network cables so that the network sig...more >>
USB to Serial converter for PC programming of Dynon units.more >>
The Dynon Primary Wiring Harness for EFIS/FlightDEK units. Fits D6, D10A, D60, D100 and D180 units.more >>
Dynon's EDC-D10A Remote Compass module permits magnetic heading to be sensed in an area of the aircraft where magnetic interfer...more >>
Dynon Mounting Tray for D100/60/120/180
All D100 series instruments come equipped with a mounting tray that permits easy fro...more >>
Dynon flush panel mount for EFIS D6/D10A or EMS D10. This mounting recesses in your panel so the front of the instrument is fl...more >>
Dynon Li-Ion Backup Battery is installed inside the EFIS or FlightDEK-D180 either at the factory or by you (if ordered after in...more >>
Dynon's EFISes and FlightDEK-D180 can be your transponder's altitude encoder. They output serial data, however, which is not su...more >>
Dynon Avionics servos are dimensionally identical to other leading servos for drop-in upgradability. Behind the scenes, though,...more >>
Brass pneumatic fitting for Dynon Pitot/Static/AOA inputs.
1/8 NPT taper thread to 1/4 inch barb.more >>
Dynon SV32 servo. Fitted with long arm. Supplied with limiting bracket kit.more >>
Dynon SV32 servo. Fitted with Capstan. Supplied with capstan accessory kit.more >>
Dynon SV42 servo. Fitted with standard arm. Supplied with limiting bracket kit.more >>
Brass Tee (barbed) for 1/4 inch (6mm) tubing.more >>
Dynon SV42 servo. Fitted with long arm. Supplied with limiting bracket kit.more >>
Dynon SV42 servo. Fitted with Capstan. Supplied with capstan accessory kit.more >>
Dynon SV42EL Servo Extra Long Output Arm.
Note: ONLY used for the Sonex Roll AP installation kitmore >>
Dynon SV42T Servo, torque enhancing linear actuatormore >>
Black nylon 6mm (1/4 inch) barbed fitting. Suitable for use on Dynon EFIS products. (3 required per EFIS/FlightDEK)more >>
Black nylon 6mm barbed tee for static/pitot lines.more >>
Dynon generic push/pull servo mounting kit.more >>
Dynon Roll Servo mounting kit for Vans RV-6 (Fuselage).more >>
Dynon Pitch Servo mounting kit for Vans RV-4 and RV-8more >>
Dynon Roll Servo mounting kit for Vans RV-7, RV-8 and RV-10. Right wing mounting.more >>
Dynon Roll Servo mounting kit for Vans RV-9.more >>
Dynon Pitch Servo mounting kit for Vans RV-6, RV-7 and RV-9.more >>
Dynon Pitch Servo mounting kit for Vans RV-10.
Requires SV42T LInear Servo (101058-003)more >>
Dynon Tiller Arm/Bow Kit - for RV-10 / RV-14 Yaw Damper Installation
Attaches to a Dynon autopilot servo to provide yaw damper...more >>
Dynon main engine sensor harness for all EMS units. One of these is supplied as part of any EMS Engine kit.more >>
Dynon EGT/CHT harness for 4 cylinder engine. One of these is supplied with any 4 cylinder engine sensor kit.more >>
Dynon EGT/CHT harness for 6 cylinder engine. One of these is supplied with any 6 cylinder engine sensor kit.more >>
Dynon EGT/CHT harness for 2 cylinder (Rotax) engine. One of these is supplied with the Rotax 912 engine sensor kit.more >>
Current sensor for EMS. 0-60Amore >>
Fuel flow rate transducer for Dynon EMS systems.more >>
Dynon carburettor temperature probe. -50F to 150Fmore >>
Dynon Manifold Air Pressure probe. 1/8 inch hose, 0-60 In Hgmore >>
The Dynon capacitance-voltage converter for Vans RV series fuel tank level sensor plates. Fitted with BNC connector for direct ...more >>
Dynon Cylinder Head Temperature probe. Ring terminal type. 12mm - suitable for Jabiru.more >>
Dynon CHT bayonet type probe. 3/8-24 UNF for Lycoming, Continental or Superior engines.more >>
Dynon EGT Clamp Probe
Exhaust Gas Temperature probe. 1.00-2.00 inch Hose Clamp type suitable for Lycoming and Continental e...more >>
Dynon EGT Clamp Probe
Exhaust Gas Temperature probe. 0.25-1.25 inch Hose Clamp type suitable for Rotax 912 engines.more >>
Dynon EGT Clamp Probe
Exhaust Gas Temperature probe. 0.75-1.75 Hose Clamp type suitable for Jabiru engines.more >>
Dynon OAT Probe
EMS Outside Air Temperature probe.
Use with EMS-D10/D120 or FlightDek D180 units.
Supplied with 3m ...more >>
Dynon EFIS OAT probe.
Connects directly to EDC-D10A Remote Compass module.
Use with any Dynon EFIS or FlightDek unit.more >>
Replacement vehicle power cable for D1/D2 Pocket Panel.more >>